RCEXL Kabel Magnet Sensor 40cm untuk Mesin DLE

Rcexl Ignition Replacement Hall Sensor Kit (includes sensor and bracket) Panjang kabel 40cm These are replacement ignition units for those engine that use Rcexl as original equipment. (Example DLE, GP, RCGF) This option comes with short reach (single cylinder) bracket and long reach (twin cylinder) an wedges to lock the hall sensor into the bracket. Use a tiny drop of thin CA on the wedge to keep it from coming out. Also, note, a hall sensor will only work with correct orientiation to the magnet so it is best to check the orientation before gluing in the wedge. To check hall effect sensor orientation, pull spark plug from the engine and place it in the ignition cap. Power up the ignition and rub the end of the hall sensor over your engine magnet. If the spark plug does not spark, flip the hall sensor 180 degrees and check again. Once the ignition sparks you will know the correct orientation to mount in in the plastic bracket. The Rcexl ignition runs best at 28 degrees before top dead center timing.

Kabel Magnet Sensor 40cm